Flywheel, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi TT Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is removed. Refer to TRANSMISSION, REMOVING AND INSTALLING .
CAUTION:
Risk of destroying the flywheel.
- Remove the bolts -B- by hand. Do not use an air-powered or impact wrench.
- When removing the bolts, make sure that the bolt head does not come in contact with the flywheel.
- Turn the flywheel -A- so that the bolts -B- line up with the center of the holes -arrows-.
-- Place the :3067 into the hole on the cylinder block -B-.
-- Loosen and remove the bolts for the flywheel and remove the flywheel and sensor wheel.