Front Bonded Rubber Bushing On SUBFRAME, Replacing, AWD Vehicles: Notes
Special tools and workshop equipment required
- Torque Wrench, 40-200Nm:VAG1332A
- Hydraulic Press:VAS6178 with Bearing Installer - Wheel Hub/Bearing Kit- Adapter 13:T10205/13
- Pneumatic/Hydraulic Foot Pump:VAS6179
- Hydraulic Press - Rear Subframe Bushing Tool Kit:T10263
- Subframe Bushing Assembly Tool Kit:T10356A
- Assembly paste. Refer to the Parts Information.
NOTE:
If a bonded rubber bushing is faulty, then the bonded rubber bushing on the opposite side must also be replaced. Refer to the Parts Information for allocation.
Check the other bushings before replacing a faulty bonded rubber bushing.
If there are any tears or other visible damages, replace the bonded rubber bushing.
Identify the installation position to the subframe before removing the bonded rubber bushing.