LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis (Single Page) >> Body & Frame >> Windows >> Exterior Equipment (2 Of 2) [Roadster] >> 66 Exterior Equipment >> Name Badges And Emblems >> Name Badges, Removing And Installing

Name Badges, Removing And Installing

CAUTION:
  • Name badges and emblems that are removed must be replaced.
  • The vehicle must reach room temperature before installing the bonded name badge and emblems.
  • The adhesive surface on the body must be free of dirt and grease, as well as free of adhesive residue.
  • Clean the adhesive surfaces using Cleaning Solution:D 009 401 04  .
  • Warm the adhesive surfaces to approximately 40 °C (104 °F) using a hot air blower.
  • After successfully assembling, press on the emblems again with the roller.

Special tools and workshop equipment required 

scientia non olet · About LEMON Manuals