Overview - Fixed Spoiler From My 2019
- Rear Lid
- Nut
- 2 Nm
- Replace after removing.
- Quantity: 2
- Emergency Release Cable Bracket
- Roadster
- Bolt
- 8 Nm
- Replace after removing.
- Quantity: 2
- Adjusting. Refer to SPOILER, ADJUSTING .
- Spoiler Mount
- Lower
- With seal
- Replace the mount if the seal is damaged
- Removing and Installing. Refer to LOWER MOUNT FOR THE SPOILER, REMOVING AND INSTALLING, FIXED .
- Adjusting Mechanism
- Equipped with a new seal -item- 7 clipped in the spoiler
- Adjusting. Refer to SPOILER, ADJUSTING .
- Seal
- Replace after removing.
- Self-adhesive
- Spoiler Trim
- Removing and Installing. Refer to SPOILER TRIM, REMOVING AND INSTALLING .
- Bolt
- 7 Nm
- Replace after removing.
- Quantity: 6
- Sealing Piece
- Replace after removing.
- Quantity: 4
- Self-adhesive
- Spoiler Mount
- Upper
- Removing and Installing. Refer to SPOILER, REMOVING AND INSTALLING .
- Sealing Piece
- Replace after removing.
- Quantity: 4
- Self-adhesive
- Spoiler
- Removing and Installing. Refer to FIXED SPOILER, REMOVING AND INSTALLING .
- Disassembling and assembling. Refer to SPOILER, DISASSEMBLING AND ASSEMBLING .
- Cap
- Inner
- Removing and Installing. Refer to SPOILER CAP, REMOVING AND INSTALLING .
- Bolt
- 4.5 Nm
- Quantity: 2
- Cap
- Outside
- Removing and Installing. Refer to SPOILER CAP, REMOVING AND INSTALLING .
- Cover
- Replace after removing.
- For bolt
- Seal
- Replace after removing.
- Self-adhesive
- Adapter Plate
Removing and Installing. Refer to SPOILER TRIM, REMOVING AND INSTALLING .
- Bolt
- 8 Nm
- Replace after removing.
- Quantity: 3
- Bolt
- 5 Nm
- Replace after removing.
- Quantity: 2
- Bracket for Spoiler
- Removing and Installing. Refer to SPOILER BRACKET ON REAR LID, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Cover
- Bolt
- 8 Nm
- Mount with Water Drain Hose
- Replace after removing.
- When attaching on the mount pay attention to the mark
- Retaining Plate
- Nut
- Replace after removing.
- Tightening specification and sequence. Refer to Figure.
- Quantity: 2
- Nut
- Replace after removing.
- Tightening specification and sequence. Refer to Figure.
- Quantity: 11