Seat Depth Adjuster Seat Cushion, Removing And Installing: Removing
- Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS FOR PYROTECHNIC COMPONENTS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker pin, for example.
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Fasten the front seat on the :VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Equipped on some models: remove the storage compartment. Refer to OWNER'S MANUAL, FIRE EXTINGUISHER AND STORAGE COMPARTMENT BRACKET, REMOVING AND INSTALLING .
-- Equipped on some models: disconnect the connector for the heated seat extension.
-- Move the seat depth adjuster all the way forward.
-- Push together the tabs in direction of -arrows- on the trim -1- with pliers or release with the :3409 .
-- Remove the trim from the seat depth adjuster.
-- Release the retaining tabs in direction of -arrow- on the support using the :3409 from the seat depth adjuster.
-- At the same time remove the support -1- with seat depth adjustment cushion and cover upward.
-- Disengage the tabs -arrows- from the seat depth adjustor -2- and move the support with cushion and cover upward.
-- Remove the support -1- with cushion and cover for the seat depth adjustor upward and forward at the same time.
-- Remove the retaining channel -2- from the retainers -5-.
-- Disengage the cover from the retainers -4- on both sides.
-- Remove the seat depth adjuster seat cushion -3- from the cover -1-.