Overview - Spoiler

Fig 1: Exploded View Of Electric Spoiler

Courtesy of AUDI OF AMERICA, LLC

1. Nut
   • Quantity: 13
   • Tightening specification and sequence. Refer to Fig 2.
2. Mount with Drive Unit
   • For the spoiler
   • With seal
   • Replace the mount if the seal is damaged
   • Removing and installing. Refer to MOUNT WITH SPOILER DRIVE UNIT, REMOVING AND INSTALLING .
3. Foam Seal
   • Self-adhesive
   • Replacing
4. Bonding Point
   • For the 10 mm diameter hole
   • Quantity: 4
   • Apply on the inside on the spoiler
5. Plugs
   • For the 30 mm diameter hole
   • Quantity: 2
   • Insert on the inside in the spoiler
6. Buffer in the Center
   • Place on the marking and press firmly
   • Clean the adhesive surface of the spoiler using Cleaning Solution:D 009 401 04  .
   • The application temperature is a minimum 18 °C (64.4 °F)
7. Spoiler
   • Removing and installing. Refer to SPOILER, REMOVING AND INSTALLING .
8. Side Buffer
   • Quantity: 2
   • Place on the marking and press firmly
   • Clean the adhesive surface of the spoiler using Cleaning Solution:D 009 401 04  .
   • The application temperature is a minimum 18 °C (64.4 °F)
9. Adjusting Mechanism
   • Equipped with a new seal -3- clipped in the spoiler
   • Adjusting. Refer to Fig 2.
10. Buffer
    • Inserted in the rear lid
    • Clean the adhesive surface on the rear lid with Cleaning Solution:D 009 401 04  .
    • The application temperature is a minimum 18 °C (64.4 °F)
    • Removing and installing. Refer to BUFFER, REMOVING AND INSTALLING .
11. Bolt
    • 8 Nm
    • Adjusting. Refer to Fig 2.
12. Water Drain Hose
    • When attaching on the mount -2- pay attention to the marks.
13. Mount
    • For the water drain

Spoiler - Tightening Specification and Sequence

Fig 2: Spoiler - Tightening Specification and Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nuts to 2 Nm in the following sequence: -1 through 13-.