Rear Lid. Adjusting, Stop Buffer

• Gap dimensions. Refer to REAR LID, ADJUSTMENT DIMENSIONS .

Procedure 

-- Install the adjusting screw -2- and cap -1- all the way into the stop buffer -3- before adjusting the rear lid.

-- Remove the adjusting screw -2- just enough until the cap -1- makes contact with the stop on the body side with light pretension when the rear lid is closed.

-- Check if the rear is without tension and closes flush by pressing or pulling at the side edges of the rear lid.

-- Repeat the adjustment if necessary.

Fig 1: Adjusting Screw, Adjusting Buffer And Cap

Courtesy of AUDI OF AMERICA, LLC