Rear Impact Guard, Removing And Installing: Installing
Install in reverse order of removal and note the following:
- The vehicle and the impact guard must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution:D 009 401 04 and let dry.
-- Remove the protective foil from the adhesive tapes -2 and 5-.
-- Place the rear impact guard -1- on the hood -3- to do so push the securing tabs -4- in the mounts -arrows-.
-- Press in the rear impact guard along the entire length using the : 3356 .
- Vehicle resting time is at least 30 minutes at room temperature.