Side Reinforcement Brace, Removing And Installing: Removing

-- Remove the molded foam part. Refer to MOLDED FOAM PART, REMOVING AND INSTALLING .

-- Remove the pressure hose sensor for front pedestrian protection -1- and free up the pressure hose -5-. Refer to Pressure Hose Sensor for Front Pedestrian Protection -G579-, REMOVING AND INSTALLING .

-- Free up the wiring harness -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -4-.

-- Release the catches -arrows-.

-- Disconnect the washer fluid hose from the headlamp washer system spray nozzle.

-- Remove the reinforcement brace -2- to the rear.