Glove Compartment, Removing And Installing: Installing

WARNING:

On vehicles with the Front Passenger Airbag Deactivation Key Switch -E224-, follow the safety precautions for pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
Before handling pyrotechnic components and restraint systems (for example, connecting the electrical connector), the person handling them must "discharge static electricity". This can be done by touching the door striker, for example.
Make sure the connectors are installed correctly and are secure.

Install in reverse order of removal. Note the following:

-- Press the electrical connector together until it engages audibly.

-- Turn on the ignition.

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

CAUTION:

When working on vehicles with the ignition already switched on or that are ready to drive there is a danger of the engine starting unexpectedly and of being poisoned by gas in enclosed areas. Risk of body parts and/or clothing being clamped or pulled.

Perform the following before switching on the ignition:

Move the selector lever into P.
Activate the parking brake
Turn off the ignition.
Open the hood
Connect Battery ChargerVAS5095A to the battery jump start terminal.
Turn on the ignition.

-- Connect the battery ground cable with the ignition turned on. Refer to GROUND CABLE WITH Battery Monitoring Control Module -J367-, REMOVING AND INSTALLING .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault, check the DTC memory, erase it and check it again.