Right Temperature Door Motor -V159-, REMOVING AND INSTALLING: Removing

-- Turn on the ignition.

-- Set the airflow direction to the instrument panel vents for both the driver and front passenger side on the Climatronic Control Module -J255- A/C display and control head.

NOTE:

In the "air to the instrument panel vents" setting, the Right Center Vent Motor -V111- -B- moves the curved washer -A- in a position in which the bolt -C- is accessible. If the Right Center Vent Motor -V111- -B- does not move the curved washer -A- into the desired position, then remove the actuator if necessary (refer to Right Center Vent Motor -V111-, REMOVING AND INSTALLING ) and move the curved washer by hand.

Fig 1: Identifying Screws -C- & -E- And Connector -D-

Courtesy of AUDI OF AMERICA, LLC

-- Move the passenger seats as far back as possible.

-- Turn off the ignition.

-- Remove the air intake housing. Refer to HEATER AND A/C UNIT AIR INTAKE HOUSING, REMOVING AND INSTALLING .

-- Mark the connector -D- (to prevent confusing it with other connectors).

-- Disconnect the connector -D-.

-- Remove the bolts -C- and -E-.

-- Loosen the pin -A- (on the actuator bracket -C-) from the toothed segment -B- (temperature door shaft) and remove the bracket -C- (with the actuator) in the direction of the -arrow-.

Fig 2: Removing/Installing Bracket -C- (With Actuator)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -A- and separate the actuator -B- from the bracket -D-.

Fig 3: Identifying Screws And Control Motor From Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove the toothed gear -C- from the actuator shaft -D-.