Defroster Door Motor -V107-, REMOVING AND INSTALLING: Removing
-- Move the driver seat as far back as possible.
-- Turn off the ignition.
-- Remove the storage compartment under the instrument panel on the driver side. Refer to Storage Compartments and Covers .
-- Remove the left footwell vent (driver side). Refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
-- Remove the accelerator pedal module. Refer to OVERVIEW - ACCELERATOR PEDAL MECHANISM for CTUC, CAEB, CPMB, CPMA and CTUD, or ACCELERATOR PEDAL MECHANISM for CPNB .
-- Mark the connector -D- if necessary (to rule out an interchange in the event several connectors are disconnected at the same time).
-- Disconnect the connector -D-.
-- Remove the bolts -C-.
To remove the bolt -C-, the Wrench - Special Ratchet T40083 may also be used.
-- Loosen the shaft -A- (on the actuator -B-) from the actuating arm -E- and remove the actuator.