Tightening Specifications, Tightening Sequence

Fig 1: Throttle Valve Control Module & Bolts

Courtesy of AUDI OF AMERICA, LLC

Tighten the bolts -arrows- to 10 Nm in a diagonal sequence.

Fig 2: Control Valve Control Unit -J808- and Bolts

Courtesy of AUDI OF AMERICA, LLC

Tighten the bolts in three steps as follows:

Fig 3: Identifying Connector And IAT Sensor/MAP Sensor Bolts

Courtesy of AUDI OF AMERICA, LLC

Tighten the bolts -arrows- to 10 Nm.

Fig 4: Installing Crankcase Ventilation Connector

Courtesy of AUDI OF AMERICA, LLC

- Install the crankcase ventilation connector -1- with new Orings into the oil separator cover.

* Installed position: the tab -2- must engage into the guide -arrow-.