Flange Input Shaft Ring, Replacing, 0BD

• The ring can only be replaced with the input shaft removed.

Special tools and workshop equipment required 

• Press Plate VW402
• Press Piece - Rod VW407
• Press Piece - Multiple Use VW412
• Bearing Installer - Multiple Use 40 - 20
• Separating tool 22 to 75 mm, such as 17/1

• Input shaft removed. Refer to INPUT SHAFT SEAL, REPLACING, 0BD .

Fig 1: Pressing Dust Cap Off Of Driveshaft Flange

Courtesy of AUDI OF AMERICA, LLC

A -

Separating Tool - 22-115mm, such as Puller - Kukko Quick Action Separating Tool - 22-115mm 17/2

Fig 2: Pressing Dust Cap Onto Driveshaft Flange

Courtesy of AUDI OF AMERICA, LLC

• Protective ring -A- installation position: the protective ring notch points upward to the Bearing Installer - Multiple Use 40 - 20.