Rear Lid Tail Lamp, Removing And Installing: Removing
-- Turn off the ignition and remove the key.
-- Turn the headlamp switch to "0".
-- Remove the outer cap on the opening -2- in direction of -arrow-.
NOTE:
Ignore item -1-.
-- Insert a screwdriver -2- into the opening and pry out the cap -1- from the inside in direction of -arrow-.
-- Disconnect the connector mount -5- on the bracket by pressing the retainer -6- in direction of -arrow- and remove the mount.
-- Disconnect the connector -7-.
-- Remove the nut -2 through 4- and remove the tail lamps -1-.