Pay attention to the installed position of the pressure line. The angle between the pressure line and the power steering pump axle is approximately 7°.

Fig 1: Identifying Hose And Union Nut

Courtesy of AUDI OF AMERICA, LLC

-- The "P" marking on the suction hose -arrow- must align with the formed seam -arrow- on the power steering pump  .

Fig 2: Identifying Suction Hose And Clamp

Courtesy of AUDI OF AMERICA, LLC

-- Install the subframe. Refer to SUBFRAME WITH STEERING GEAR, REMOVING AND INSTALLING .

-- Bleed the steering. Refer to STEERING, BLEEDING AFTER REPLACING .

-- Check the steering for leaks. Refer to STEERING, CHECKING FOR LEAKS .

-- Clean oiled places in engine compartment.

Tightening Specifications

• Refer to OVERVIEW - POWER STEERING PUMP, VEHICLES WITH DYNAMIC STEERING WITH 8-CYLINDER ENGINE 
• Engine support. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
• Refer to Exhaust Pipes/Mufflers .
• Refer to Noise Insulation, Removing and Installing .
• Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING . .