Flange/Driveshaft Ring
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2015 Audi RS 5, and 2014 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools and workshop equipment required
- Needle Bearing Drift VW 295 A
- Thrust Plate VW 402
- Punch VW 408 A
- Support Channels VW 457
- Separating Device 22 to 75 mm, for example Kukko 17/1
B - Separating Tool 12 to 75 mm, for example Kukko 17/1
Fig 2: Identifying Ring -A- Must Be Installed With Elevation -Arrow 1- Into Chamfer -Arrow 2- On Flange -B-. Smaller Outer Circumference Face Flange -Arrow 3-
- The ring -A- must be installed with the elevation -arrow 1- into the chamfer -arrow 2- on the flange -B-. The smaller outer circumference face the flange -arrow 3-.
- The ring -A- must clip into the chamfer in the flange Fig 2.