ATF Level In Rear Final Drive 0BF And 0BE, Checking
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2015 Audi RS 5, and 2014 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Test requirement
- ATF temperature: 10°C to 60°C (50°F to 140°F)
- The rear final drive must be in its installed position.
- The vehicle must horizontal.
Special Tools and workshop equipment required
- Catch tray
-- Remove the ATF inspection plug -1-.
CAUTION:
- The ATF check plug -1- is located on the left side of the rear final drive. >>ATF<< on the final drive housing -arrow-.
- Overview of the ATF plugs, refer to Figure
- The ATF level is correct when the rear final drive is filled up to the lower edge of the fluid fill hole.
If the ATF level is correct:
-- Install and tighten the new ATF inspection plug. Tightening specification, refer to item 12.
If the ATF level is not correct:
-- Fill with ATF. Refer to ATF IN REAR FINAL DRIVE 0BF AND 0BE, FILLING .