Right Timing Chain Cover, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the O-rings.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Remove any old sealant from the surfaces.

CAUTION:

Risk of contaminating the lubricating system.

Cover open parts of engine.

Fig 1: Cleaning Sealing Surfaces

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Danger of eye injury.

Wear protective eyewear.

-- Remove the sealant residue on the timing chain cover -1- and cylinder head using a rotating plastic brush, for example.

-- Clean any oil or grease off the sealing surfaces.

-- Cut the tube nozzle at the front marking (nozzle diameter: about 2 mm (0.0787 in.)).

NOTE:

Note the expiration date of the sealing compound.

Fig 2: Cut Tube Nozzle At Front Marking (Nozzle Diameter Approx. 1 Mm)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the intermediate pipe -2- from the right timing chain guard with the needle bearing drift.

-- Install the O-rings -1- in the intermediate pipe.

-- Insert the intermediate pipe into the right timing chain cover.

CAUTION:

The lubrication system could be plugged with excess sealant.

Do not apply sealant bead thicker than indicated.

NOTE: The timing chain cover must be installed within 5 minutes after applying the sealant.

-- Apply a sealant bead -arrow- to the clean sealing surfaces of the right timing chain cover as shown.

Sealant bead thickness: 2.5 mm (0.098 in.)

Fig 3: Driving Left Coolant Intermediate Pipe Out Of Left Timing Chain Cover With Suitable Drift
Courtesy of AUDI OF AMERICA, LLC

-- Position the right timing chain cover and tighten the bolts, refer to Figure.

The rest of the installation is performed in reverse order of removal, noting the following:

-- Install the upper rear coolant pipe, refer to OVERVIEW - COOLANT PIPES .

-- Install the vacuum pump, refer to VACUUM PUMP, REMOVING AND INSTALLING .

-- Connect the coolant hoses with the connector coupling, refer to Fig 4.

Fig 4: Connecting Coolant Hose Coupling

Courtesy of AUDI OF AMERICA, LLC

NOTE: Do not reuse used coolant.

-- Fill with coolant, refer to COOLANT, DRAINING AND FILLING .