Flywheel, Removing And Installing: Installing
Install in reverse order of removal. Note the following:
-- Always clean the transmission housing in the area where the differential is accessed -arrow A- and the shaft seal -arrow B-.
Replace the shaft seal between the differential and transmission housing -arrow B- if it is damaged. Refer to LEFT SEAL, REPLACING .
-- Fill the space between the sealing- and dust lip half way with sealing grease.
-- Clean the input shaft -arrow-.
-- Lubricate the input shaft splines using Grease for Clutch Disc Shaft Splines :G 000 100 .
-- Slide the clutch module onto the input shaft -arrow- carefully without tilting it.
-- Remove the Puller - Clutch Module :T40176 from the flywheel -A-.
-- Install the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .