Camshaft Adjustment Valve 2 -N208- / Exhaust Camshaft Adjustment Valve 2 -N319-, REMOVING AND INSTALLING, CYLINDER BANK 2 (LEFT): Removing
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
WARNING:
Fire hazards and risk of damage for a faulty engine cover.
- The engine cover must be always be installed before the hood is closed.
- The engine may neither be started nor driven without an engine cover.
-- Open the clamps -1 and 4- and remove the coolant hoses.
-- Free up the coolant hose -arrow-.
-- Disconnect the connector -2-.
-- Remove the bolt -3-.
-- Remove the coolant reservoir upward from the mount and move it towards the front.
-- Remove the connectors -1- from the bracket -2- disconnect them, and then free up the wires.
-- Unclip the mount upward.
-- Remove the bolt -1- and the double bolt -3- and then press the wiring guide -2- slightly forward.
-- Disconnect the connectors -2-.
-- Press the electrical wiring harness to the side.
-- Remove the affected bolt -1- and then remove the valve.