Input Shaft Ball Bearing, Replacing: Installing

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Replace the O-ring and locking rings. Refer to OVERVIEW - FLYWHEEL AND DUAL CLUTCH .

NOTE:

The clutch cover may have or may not have a thrust washer -2-, depending on the date of manufacture.

-- If it was there during the removal, then insert a thrust washer -2- into the cover -1-.

-- Install the new dual clutch ball bearing all the way.

Courtesy of AUDI OF AMERICA, LLC

-- Install the new ball bearing circlip -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Clean the sealing surface on the clutch cover.