Automatic Transmission Fluid (ATF) Strainer, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi RS 7, 2018 Audi A7 Quattro, 2017 Audi RS 7, 2017 Audi A7 Quattro, and 2016 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Mount the O-ring -2- on the ATF filter -1-.
-- Clean both magnets -arrows-. Make sure the magnets completely contact the depressions in the ATF filter.
-- Mount the ATF filter on the Mechatronic.
- The collar -1- on the ATF filter must be installed all the way into the opening -2- in the Mechatronic.
- The mount -4- on the back must fit into the bolt -3- on the Mechatronic.
-- Install the ATF pan. Refer to OIL PAN, REMOVING AND INSTALLING .
-- Fill with ATF. Refer to AUTOMATIC TRANSMISSION FLUID (ATF), DRAINING AND FILLING .