Camshaft, Removing And Installing: Installing: Notes
NOTE:
Replace the plain rectangular compression rings.
Replace any bolts that were tightened with an additional turn.
CAUTION:
Risk of contaminating lubricating system and bearing.
- Cover open parts of engine.
WARNING:
Danger of eye injury.
- Wear protective eyewear.
-- Remove the sealant residue on the cylinder head and the camshaft housing -1-, using for example a rotating plastic brush.
-- Clean any oil or grease off the sealing surfaces.
CAUTION:
The engine could be damaged.
- Pay attention to the allocation of the roller rocker lever to the cylinders.
-- Insert the hydraulic adjuster with the roller rocker lever.
- Roller rocker lever with wide rollers -arrow 1- belong to the cylinders without cylinder cut-off.
- Roller rocker lever with narrow rollers -arrow 2- belong to the cylinders with cylinder cut-off.
-- Oil running surfaces of both camshafts.
-- Place the camshafts in the cylinder head, being careful of their position so the camshaft housing can be laid on top without tension.