Cylinder Bank 1 (Right)

1. Exhaust camshaft
2. Intake camshaft

• The surfaces with the threaded openings in the direction of -arrows- must face a little towards the left and towards the engine center.
• The camshafts almost set themselves into the correct position.

-- Bring the camshaft spacers into the installed position -arrows- :

• The spacers must be slid respective to the direction of the ends of the camshafts.

-- Apply sealant beads -1 through 3- to the clean camshaft housing surfaces as shown in the illustration.

• Thickness of sealant beads: 2.5 mm.