Continuation for Both Cylinder Banks
-- Check the location of the compressor ring ends.
- The compression ring ends -1 and 2- must face upward or downward, and must never face sideways.
-- Clean and insert the oil screen -arrow-.
The engine could be damaged.
- Bring the pins of all camshaft adjustment actuators into the installation position.
-- Press down the camshaft adjustment actuator pins by hand -arrow-.
- The pins for all of the adjusting elements must not be in the outward position.
Note the expiration date of the sealing compound.
-- Cut the tube nozzle at the front marking (nozzle diameter: about 2 mm).
Risk of contaminating camshaft bearing with excess sealant.
- Do not apply sealant beads thicker than indicated.
Install the lower section of the camshaft housing within five minutes of applying the sealant.
-- Lay the camshaft housing on the cylinder head.
Ensure that the camshafts can be inserted in the camshaft housing axial bearing without force.
-- Insert the :T40116 into the camshaft housing and cylinder head.
-- Tighten the bolts for the camshaft housing. Refer to Tightening Specifications .
The cylinder head for cylinder bank 2 (left) is shown.
The sealant must harden for approximately 30 minutes after installing the camshaft housing.
-- Remove the :T40116 with the :T10133/3 .