Lower Timing Chain Cover, Removing And Installing: Removing
- Transmission removed. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING , TRANSMISSION, REMOVING AND INSTALLING or TRANSMISSION, REMOVING AND INSTALLING .
-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
-- Remove the upper rear coolant pipe. Refer to UPPER REAR COOLANT PIPE, REMOVING AND INSTALLING .
-- Remove the Engine Coolant Circulation Pump 2 -V178-. Refer to Engine Coolant Circulation Pump 2 -V178-, REMOVING AND INSTALLING .
-- Remove the upper timing chain covers. Refer to TIMING CHAIN COVER, REMOVING AND INSTALLING .
-- Disconnect the connector -2- from the Engine Speed Sensor -G28-.
Ignore item -1-.
-- Remove the bolts -arrows-.
-- Loosen and remove the bolts -2 to 8- in a diagonal sequence.
Bolt -1- is only installed on vehicles with vane pumps.
-- Carefully loosen the lower timing chain cover from the bond and remove it.
-- Press the transmission side of the crankshaft shaft seal out of the lower timing chain cover.