Tightening Specifications

Cylinder Head Bank 1 (Right)

Fig 1: Cylinder Head Bank 1 Tightening Sequence (Right)

Courtesy of AUDI OF AMERICA, LLC

Cylinder Head Bank 2 (Left)

Fig 2: Cylinder Head Bank 1 Tightening Sequence (Left)

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Replace any bolts that were tightened with an additional turn.

-- Tighten the bolts in steps in the sequence shown:

Step	Bolts	Tightening Specification/Additional Turn
1.	-1 through 10-	Install all the way in by hand.
2.	-1 through 10-	30 Nm
3.	-1 through 10-	60 Nm
4.	-1 through 10-	Tighten an additional 90°
5.	-1 through 10-	Tighten an additional 90°
6.	-Arrows-	10 Nm
7.	-Arrows-	Tighten an additional 90°

-- Check the cylinder head at several locations for distortion using a :VAS6075 and a feeler gauge.

Resurfacing cylinder head (face grinding) is only permissible to minimum dimension -a-.