Crankshaft Seal, Replacing, Transmission Side

Special Tools And Workshop Equipment Required 

• Crankshaft Seal Installer Kit :T10122B 
• Seal Installer - Crankshaft :T10122/1 
• Seal Installer - Crankshaft - Pull Sleeve :T10122/2 
• Seal Installer - Crankshaft - Thrust Piece :T10122/3 
• Puller - Crankshaft/Power Steering Seal :T20143/2 

• Transmission removed.

-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Pry out the shaft seal using :T20143/2  .

Courtesy of AUDI OF AMERICA, LLC

-- Clean the running and sealing surface.

-- Place the :T10122/1  on the :T10122/2  and slide the shaft seal -A- onto the pull sleeve.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the assembly device.

-- Position the pull sleeve :T10122/2  with shaft seal -1- on the crankshaft.

Courtesy of AUDI OF AMERICA, LLC

-- Install the shaft seal in evenly all around with :T10122/3  until flush.

Courtesy of AUDI OF AMERICA, LLC

-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .