All Wheel Drive Pump -V415-, REMOVING AND INSTALLING: Removing

-- Place the vehicle on a lift.

-- Place the Drip Tray under the rear final drive.

-- Disconnect the connector -1- from the All Wheel Drive Pump -V415- -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the four bolts that connect the All Wheel Drive Pump -V415- to the hydraulic control unit using the Hex Ball Socket :T10058 .

-- Carefully remove the All Wheel Drive Pump -V415- -2-. Pay close attention to the adapter -item 4- HYDRAULIC CONTROL UNIT, DISASSEMBLING AND ASSEMBLING inside the hydraulic pump while doing this.

NOTE:

The adapter could fall out when removing the All Wheel Drive Pump -V415-.

Insert the adapter into the recesses in the hydraulic pump before installing the All Wheel Drive Pump -V415-.