All Wheel Drive Pump -V415-, REMOVING AND INSTALLING: Installing
- The hydraulic pump -A- is installed inside the hydraulic control unit. Assembling the hydraulic pump. Refer to 23.
- The adapter -B- is installed in the recesses in the hydraulic pump.
- A new O-ring -D- is on the All Wheel Drive Pump -V415-.
-- Install the All Wheel Drive Pump -V415- with the coupling -C- in the adapter -B-.
-- Diagonally tighten the four bolts on the All Wheel Drive Pump -V415- -2- to the tightening specification -item 1- HYDRAULIC CONTROL UNIT, DISASSEMBLING AND ASSEMBLING.
-- Connect the connector -1- to the All Wheel Drive Pump -V415-.
-- Fill with ATF in the rear final drive. Refer to ATF ON REAR FINAL DRIVE 0BF AND 0BE, FILLING .