All Wheel Drive Clutch Valve -N445- OR All Wheel Drive Clutch Valve 2 -N446-, REMOVING AND INSTALLING: Removing
- The ignition is off.
-- Place the vehicle on a lift.
-- Lower the back section of the exhaust system just a little and secure it.
-- Remove the wiring harness bracket from the rear final drive. Refer to Removing .
Mark the connectors -1 through 4- for the Oil Pressure/Temperature Sensor -- and for the Clutch Valves --.
Disconnect the connectors -1 and 2-.
-- Disconnect the connector -3- from the All Wheel Drive Clutch Valve 2 -N446- and the connector -4- from the All Wheel Drive Clutch Valve -N445-.
-- Place the Drip Tray under the rear final drive.
-- Remove the bolts -1- from each of the Clutch Valves -- using the Hex Socket - 4 mm :T10370 .
-- Carefully pry out the Clutch Valve -- with a flat blade screwdriver -3-. Be careful of the pressure spring when doing this. The pressure spring could fall out of the opening in the hydraulic control unit -6-.
-A- = All Wheel Drive Clutch Valve 2 -N446- identification color brown
-B- = All Wheel Drive Clutch Valve -N445- identification color black