All Wheel Drive Control Module -J492-, REMOVING AND INSTALLING

NOTE:

All Wheel Drive Control Module -J492- component location -item 1- ELECTRICAL/ELECTRONIC COMPONENTS AND COMPONENT LOCATIONS.

Removing and installing is on the A4 Sedan.

-- Remove the luggage compartment floor covering.

-- Remove the covering and the vehicle tools mount.

-- Remove the All Wheel Drive Control Module -J492- -A- from the bracket -C-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -B- from the All Wheel Drive Control Module -J492-.

-- Install the All Wheel Drive Control Module -J492- in reverse order of removal.

If the All Wheel Drive Control Module -J492- was replaced then additional work is necessary. Refer to All Wheel Drive Control Module -J492-, ADDITIONAL WORK AFTER REPLACING .