Selector Shaft, Cleaning
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi A4, 2015 Audi A4, 2014 Audi A4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Procedure
- End cover removed. Refer to END COVER, REMOVING AND INSTALLING .
- Transmission Control Module -J217- is removed. Refer to TRANSMISSION CONTROL MODULE, REMOVING AND INSTALLING .
NOTE:
Refer to REPAIR INFORMATION .
Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Clean the selector shaft catch -arrows-. Use a lint-free cloth. Clean contact surfaces of magnet especially thoroughly. Make sure there no metal shavings on it.
NOTE:
Make sure that spring -1- and the roller -4- are secured properly.
-- Check the roller -4- and spring -1- for damage; replace if necessary.