Overview - End Cover
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi A4, 2015 Audi A4, 2014 Audi A4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Danger of causing damage to the transmission.
- Do not let the engine run or tow the vehicle when the cover is removed or when there is no Automatic Transmission Fluid (ATF) in the transmission.
NOTE:
Refer to REPAIR INFORMATION .
Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Transmission
- Small Axial Sealing Element
- Replacing
- Large Axial Sealing Element
- Replacing
- Roller
- Lever
- For the selector lever lock mechanism
- Spring
- Seal
- For the Transmission Control Module -J217- connector
- Bolt
- 10 Nm +90° turn
- Replacing
- Quantity 12, tighten diagonally
- Cover
- Removing and installing with the transmission installed. Refer to END COVER, REMOVING AND INSTALLING .
- Removing and installing, refer to END COVER, REMOVING AND INSTALLING
- Seal
- Replacing
- Bolt
- 5 Nm + 90° turn
- Quantity: 3
- Transmission Control Module -J217-
- Bolt
- 5 Nm + 90° turn
- Quantity: 3
- Hydraulic Control Unit