LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> S6 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Exterior Body Panels (Hood, Lids) (Sedan)) >> (55 Hood, Lids) >> Hood >> Insulation, Removing And Installing

Insulation, Removing And Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Hood Insulation
GWWA55-10307Courtesy of AUDI OF AMERICA, LLC
  1. Clip
  2. Hold Panel
    • Installation:

      -- Slide the lining over the tabs on the rear edge into the holes provided on the inner panel.

      -- Slide the tabs on the front edge and the sides into place.

      -- The clips must engage audibly when pressing in.

      -- Press the clip in.

  3. Door
  4. Clip