Input Shaft Seal, Replacing
Special tools and workshop equipment required
- Pulling Hook T20143/2
- Seal Installer - Input Shaft T40198
- Grease.
Procedure
- Secure the transmission on the Engine And Transmission HolderVAS6095. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .
-- Remove the flywheel. Refer to FLYWHEEL, REMOVING AND INSTALLING .
-- Pry out the input shaft seal with the Pulling Hook T20143/2.
-- Place the Seal Installer - Input Shaft Guide Sleeve T40198/1 on the drive axle.
-- Lightly coat the outer circumference of the new shaft seal with oil.
-- Fill the space between the sealing- and dust lip half way with sealing grease.
-- Install the shaft seal on the guide sleeve.
- Installed position: Open side of shaft seal faces transmission.
-- Drive in the shaft seal with the Seal Installer - Input Shaft T40198 until it stop without tilting.
-- Install the flywheel. Refer to FLYWHEEL, REMOVING AND INSTALLING .