Fastener Tightening Specifications: Notes
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2015 Audi RS 5, and 2014 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
| Component | Fastener Size | Nm |
|---|---|---|
| All Wheel Drive Clutch Valve to Hydraulic Control Unit Housing Bolt | - | 2.5 |
| All Wheel Drive Pump to Hydraulic Control Unit Housing Bolt | - | 5 |
| Automatic Transmission Fluid Drain Plug to Final Drive Housing | - | 15 |
| Automatic Transmission Fluid Inspection Plug to Left Chamber | - | 15 |
| Bracket for the Wiring Harness | 9 | |
| Center Bearing | - | 20 |
| Drive Axle Heat Shield to Rear Final Drive Bolt | - | 20 |
| Driveshaft Center Bearing to Body Bolt | - | 20 |
| Driveshaft to Rear Final Drive Flange Bolt 1 | - | 30 + 90° |
| Driveshaft to Transmission Flange Bolt 1 | - | 30 + 90° |
| Flange Shaft to Rear Final Drive Bolt 1 | - | 50 + 180° |
| Gear Oil Inspection Plug to Final Drive Housing | - | 15 |
| Hydraulic Control Module to Final Drive Housing Bolt | ||
| M8 2 | 20 | |
| M8 3 | 20 | |
| M8 4 | 30 | |
| Left Pipe Installed between the Hydraulic Control Unit and the Left Chamber, Nuts | - | 30 |
| Left/Right Chamber to Final Drive Housing Bolt | - | 24 |
| Oil Pressure/Temperature Sensor to Hydraulic Control Unit Housing | - | 10 |
| Right Pipe Installed Between the Hydraulic Control Unit and the Right Chamber, Nuts | - | 30 |
| Shuttle Valve to Hydraulic Control Unit Housing | - | 8 |
| Subframe to Rear Final Drive | ||
| - Lower Bolt | - | 55 |
| - Rear Bolt | - | 95 |
| Wiring Harness Bracket to Right Chamber Bolt | - | 5 |
| Wiring harness bracket to the rear final drive | - | 9 |
|
||