All Wheel Drive (AWD): Pump: Removing
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2015 Audi RS 5, and 2014 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
-- Place the vehicle on a hoist.
- Turn off the ignition.
-- Place the drip tray under the rear final drive.
-- Disconnect the connector -1- from the All Wheel Drive (AWD) pump -V415- -2-.
-- Remove the 4 AWD pump bolts on the hydraulic control unit using the T10058.
-- Carefully remove the AWD pump -2- while paying attention to the adapter, refer to item 4 in the hydraulic pump.
NOTE:
- The adapter could fall out when removing the AWD pump.
- Insert the adapter into the recesses in the hydraulic pump before installing the AWD pump.