All Wheel Drive (AWD): Pump: Installing
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2015 Audi RS 5, and 2014 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- The hydraulic pump -A- is installed inside the hydraulic control unit in its Installed position; assembling the hydraulic pump. Refer to Figure.
- The adapter -B- is installed into the recesses in the hydraulic pump.
- The new O-ring -D- is installed on the AWD pump.
-- Install the AWD pump and the shaft -C- into the adapter -B-.
-- Tighten the four bolts on the AWD pump -2- diagonally, refer to item 1.
-- Connect the connector -1- to the AWD pump.
-- Fill the ATF in the rear final drive. Refer to ATF IN REAR FINAL DRIVE 0BF AND 0BE, FILLING .