AWD Control Module, Additional Work After Replacing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2015 Audi RS 5, and 2014 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools and workshop equipment required

Vehicle Diagnostic Tester

NOTE:

Perform the following only if the All Wheel Drive (AWD) control module -J492- was replaced.

-- Connect the vehicle diagnostic tester and turn on the ignition.

-- Select 22 - Replace Control Module in the vehicle diagnostic tester under Guided Functions in directory 22 - AWD Electronics

Follow all the instructions in the VAS 5051 exactly.

Using the vehicle diagnostic tester, "adapt" the rear final drive, which was just installed, to the AWD control module.

NOTE:

A system check takes place after 22 - Replace Control Module finishes. Use "Guided Fault Finding" to correct any malfunctions that may have been detected.