Pressures, Checking

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Refrigerant circuit with expansion valve, receiver/dryer with or without A/C Clutch -N25- and A/C Compressor Regulator Valve -N280- (with an A/C compressor regulated from the outside)

NOTE:

Connect the A/C service station. Refer to A/C SERVICE STATION ON REFRIGERANT CIRCUIT, CONNECTING .

If a malfunction occurs at only one evaporator in vehicles with two evaporators, check pressures in the refrigerant circuit; if they are OK, check line connection between malfunctioning evaporator and line connection end at distribution point of refrigerant lines (for constrictions or blockage). If no malfunction can be determined, empty the refrigerant circuit and refill with the specified refrigerant quantity. Then check the pressures and the A/C system cooling output again; if the complaint still exists, replace the expansion valve that is prematurely switched by the questioned evaporator. Refer to REFRIGERANT CIRCUIT .

Refer to REFRIGERANT CIRCUIT WITH IGNITION SWITCHED ON, CHECKING PRESSURE