LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> S5 2D Convertible >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> GENERIC SCAN TOOL [CGXC, CTUA, CTUB, CTUC, CTUD] (5 Of 5) (CABRIOLET) >> Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions - 2013, 2014 MYS >> Monitor-ID A3: Mis-Fire Cylinder 2 Data

Monitor-ID A3: Mis-Fire Cylinder 2 Data

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6 Check test the results of components that are not continuously monitored".

Select "Monitor-ID A3:".

-- Select the desired "Test-ID (TID)" or "Hex-ID".

-- Check specified values at idle.

Test-ID (TID) DTC Component or System Min./Max. Values Additional Information
$0B P0302 Misfire cylinder 2, Average value over 10 Driving Cycles. 0 - 65535 (counts) Refer to DTC P0302 in the DTC summary table. Engine Control Module --, 2013 - 2014 MY
$0C P0302 Misfire cylinder 2, Current Driving Cycle. 0 - 65535 (counts) Refer to DTC P0302 in the DTC summary table. Engine Control Module --, 2013 - 2014 MY .

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition off.

scientia non olet · About LEMON Manuals