Monitor-ID $3C: Fuel Tank EVAP System Integrity/Leak Test (0.20/0.5mm)
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Monitor-ID 60 ($3C)".
-- Select the desired "Test-ID (TID)" or "Hex-ID".
-- Check specified values at idle.
| Test-ID (TID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $83 | P0456 | Fuel Tank EVAP NVLD System leak test: Pinhole leak (0.5 mm). | 10 minutes (duration of Very Small leak diagnosis) | 65535 ms (34h) | Refer to DTC P0456 in the DTC summary table. Engine Control Module --, 2013 - 2014 MY |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.