Monitor-ID $35: Cam Shaft Adjustment diagnosis bank 1
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Monitor-ID 53 ".
-- Select the desired "Test-ID (TID)" or "Hex-ID".
-- Check specified values at idle.
| Test-ID (TID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $80 | P0011 | Intake (A) Camshaft Position Timing - Over-Advanced Bank 1 | 0° KW | 10.125° KW | Refer to DTC P0011 in the DTC summary table. Engine Control Module --, 2013 - 2014 MY |
| $81 | P000A | Intake (A) Camshaft Position Slow Response Bank 1 | 4.875° KW | 655.35° KW | Refer to DTC P000A in the DTC summary table. Engine Control Module --, 2013 - 2014 MY |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.