Intake Manifold Runner Control Valve -N316-, Checking

General Description

The intake manifold runner valve(s) are mounted on a common shaft and actuated by a vacuum cell. The partial vacuum required for actuation is supplied by the Intake Manifold Runner Control Valve -N316-. The Engine Control Module -J623- activates the Intake Manifold Runner Control Valve -N316- on the basis of a characteristic map.

Special Tools And Workshop Equipment Required

Multimeter.
Wiring Diagram.
Scan Tool.

Test Requirements

Fuses OK.
Battery voltage OK.
Switch OFF All electrical and electronic accessories.
Vehicles with Auto. Transmission, ensure Selector Lever position is in "P".
Vehicles with Manual Transmission, ensure Shifter Lever position is in "N" with Parking Brake applied.
Observe all safety precautions: SAFETY PRECAUTIONS .
View clean working conditions: CLEAN WORKING CONDITIONS .

Test Procedure

Step	Procedure	Result / Action to Take
1	PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK . -- Was Complaint verified?	-- YES: GO TO: Step 2 Intake Manifold Runner Control Valve -N316-, CHECKING - 2 . -- NO: GATHER more information from customer about the complaint.
2	IGNITION: OFF. DISCONNECT: Intake Manifold Runner Control Valve -N316- harness connector. CHECK: Intake Manifold Runner Control Valve -N316- component connector terminals 1 to 2 for resistance. SPECIFIED VALUE: 12 - 20 Ω (@ approx. 20° C). -- Was Value obtained?	-- YES: GO TO: Step 3 Intake Manifold Runner Control Valve -N316-, CHECKING - 3 . -- NO: REPLACE: Intake Manifold Runner Control Valve -N316-. Refer to the appropriate service information. GO TO: Step 5 Intake Manifold Runner Control Valve -N316-, CHECKING - 5 .
3	IGNITION: ON. CHECK: Intake Manifold Runner Control Valve -N316- harness connector terminal 2 to ground for voltage. IGNITION: OFF. SPECIFIED VALUE: Battery voltage. -- Was Value obtained?	-- YES: GO TO: Step 4 Intake Manifold Runner Control Valve -N316-, CHECKING - 4 . -- NO: PERFORM: Visual Inspection of wiring and component. CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 5 Intake Manifold Runner Control Valve -N316-, CHECKING - 5 .
4	REMOVE: Engine Control Module - J623-. Refer to the appropriate service information. CHECK: Intake Manifold Runner Control Valve -N316- harness connector terminal 1 to the Engine Control Module - J623- harness connector T60 / 36 for resistance. SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω). -- Was Value obtained?	-- YES: GO TO: Step 5 Intake Manifold Runner Control Valve -N316-, CHECKING - 5 . -- NO: PERFORM: Visual Inspection of wiring and component. CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 5 Intake Manifold Runner Control Valve -N316-, CHECKING - 5 .
5