Upper Transverse Link: Installing

NOTE:

Replace The Bolts And The Self-Locking Nuts.

Installation position of the transverse link to the subframe

-- Install the upper transverse link -3- on the threaded connection -1- by hand.

Fig 1: Connections -1- & -2- & Upper Transverse Link -3-

Courtesy of AUDI OF AMERICA, LLC

-- Lay a ruler or straight edge -1- flat against the upper transverse link -arrows-.

Fig 2: Lay A Ruler Or Straight Edge Flat Against Upper Control Arm

Courtesy of AUDI OF AMERICA, LLC

-- Position the upper transverse link -2- so dimension a = 8 mm +/- 1 mm between the straight edge -1- and the stamping burr on the upper transverse link -2-.

-- Tighten the upper transverse link -3- on the subframe in this position.

Fig 3: Connections -1- & -2- & Upper Transverse Link -3-

Courtesy of AUDI OF AMERICA, LLC

-- Screw wheel bearing housing on control arm and tighten new nut to 20 Nm. Note the installation position of the centering washer -2-.

-- Install subframe on vehicles with front-wheel drive (FWD). Refer to SUBFRAME WITH ATTACHMENTS .

-- Install subframe on vehicles with all-wheel drive (AWD). Refer to SUBFRAME WITH ATTACHMENTS .

-- Loosen the threaded connection -1-.

Fig 4: Identifying Threaded Connection

Courtesy of AUDI OF AMERICA, LLC

-- Lift the wheel bearing hub into curb weight position. Refer to WHEEL BEARING WITH COIL SPRING, LIFTING TO CURB WEIGHT POSITION and tighten the threaded connection -1-.

Tightening specifications, refer to UPPER TRANSVERSE LINK, TIE ROD, COIL SPRING, LOWER CONTROL ARM AND LEVEL CONTROL SYSTEM SENSOR OVERVIEW .

-- Tighten wheel. Refer to SPECIFICATIONS .

-- An axle alignment may be required. Refer to WHEEL ALIGNMENT .

NOTE:

The wheel alignment must be performed on a VW/Audi approved alignment stand.