Wheel Bearing Unit, Front Wheel Drive (Fwd), Removing And Installing: Installing
Installation is the reverse of removal, With Special Attention To The Following:
Tightening Specifications. Refer to OVERVIEW - WHEEL BEARING, VEHICLES WITH FRONT WHEEL DRIVE (FWD) .
-- Install the front seal and grease the stub axle -arrow- lightly with Grease.
-- Install the brake caliper and the brake rotor. Refer to REAR BRAKE CALIPER, REMOVING AND INSTALLING .
Damaged (Dented) Protective Cap Must Be Replaced.
A Damaged (Dented) Protective Cap Allows Moisture To Enter. Therefore, Always Use The Tool Shown.
-- Drive in the protective cap with the :3241/4 .
-- Install the wheel.
-- Tighten the wheel. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .
-- Tighten the wheel bearing unit collar bolt, but only when the vehicle is resting on its wheels. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .