Installing A Clamp On The Inner Joint And Clamping

Fig 1: Attaching CV Joint Boot Clamp Tool VAG 1682

Courtesy of AUDI OF AMERICA, LLC

-- Attach the :VAG1682A  as illustrated. Make sure that the jaws of the tension clamp seat in the corners -arrows B- of the connecting tube.

-- Tighten the clamp by turning the spindle using a torque wrench -C- (do not tilt the pliers).

• The hard material of the CV boot (compared to rubber) makes it necessary to use a stainless steel hose clamp. It is only possible to tighten the hose clamp with :VAG1682A  .
• Tightening specification: 20 Nm.
• Use torque wrench with 5 to 50 Nm range (for example, :VAG1331  ).
• make sure the spindle threads on the pliers -A- move freely. Grease with MoS₂ grease if necessary.
• If the thread is tight, for example, dirty, the required tensioning force for the hose clamp will not be achieved in spite of correct torque specification settings.