Level Control System Control Module -J792-: Removing

NOTE:

The active steering control module -J792- is located in the footwell under the driver seat.

Before removing control module, read out code using Guided Fault Finding in "Replace control module" function.

-- Loosen the driver seat and slide it back with the wires connected.

-- Remove the sill panel strip. Refer to SILL PANEL STRIP, REMOVING AND INSTALLING .

-- Remove the foot rest. Refer to FOOT REST, REMOVING AND INSTALLING .

-- Disengage the carpet and support it using a suitable wood block -6-.

Fig 1: Disengage Carpet And Support It Using A Suitable Block Of Wood

Courtesy of AUDI OF AMERICA, LLC

-- Remove nuts -7-.

-- Remove the nuts -1- and remove the ground wire -2- from the threaded pin.

-- Carefully disconnect the wiring harness clip connection -3- from the bracket -4-.

-- Remove the wiring harness connectors -3- from the control module -8-.

-- Remove the bolts -5- from the control module -8- and remove the bracket -4-.